User Manual

“Digital Control Panel” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
201
❑ “Digital Control Panel” dialog box
Here you can assign the MTX/MRX’s parameters to the controls of a digital control panel (DCP)
such as the DCP1V4S so that they can be operated from the DCP. You can also make settings for
the brightness of the DCP unit’s LEDs, as well as panel lock settings. You can’t make settings while
online. (Settings can only be viewed.)
You can store 32 sets of DCP settings in the Library. You can also associate library items with presets
for recall.
After editing in a tab such as [Parameter Assign]/[Dimmer & Lock]/[Source Select], click the item
in the [Library] list to which you want to save, and then click the [Save] button to save the item to
the library.
In the [Library] list, click the library item that you want to load, and then click the [Load] button to
load the library item; the settings will be applied to tabs such as [Parameter Assign]/[Dimmer &
Lock]/[Source Select].
• If you associate a saved library item with a preset, the parameter assignments for all DCP
units (up to 32 units) connected to the MTX/MRX system will be recalled/stored in a single
action when you recall that preset. If you want to recall only a specific DCP, open the
“Preset” dialog box and make [Recall Filter] settings.
• You must use the “Device Configuration Wizard” dialog box to assign the MTX/MRX and
DCP units and specify their ID settings beforehand. If you have not made these settings yet,
you won’t be able to open the “Digital Control Panel” dialog box; an alert will be displayed.
• The [Source Select] tab is shown if there is an MRX unit in the MTX/MRX system. For details,
refer to “MRX Designer User Guide.”
● MTX/MRX selection box
Selects the MTX/MRX to which the target DCP unit is connected. The box will list
units in order of UNIT ID, followed by the name of the MTX/MRX.
● DCP selection box
Select the DCP unit for which you want to make settings. All DCP units that are
connected to the MTX/MRX (which is selected in the MTX/MRX selection box) are
listed in order of UNIT ID and the name of the DCP unit.
The model and graphic for the selected DCP are shown below the DCP selection box.
The control selected in the [Parameter Assign] tab will be highlighted.
NOTE