User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“PGM1/PGX1” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
217
❑ “PGM1/PGX1” dialog box
Here you can make assignments for the zone/message select buttons of the PGM1 and PGX1, and
make settings for the PTT button.
This dialog box can shown only for the MTX5-D or MRX7-D. If using the PGM1 with the
MRX7-D, use MRX Designer to place the “Paging” component.
● MTX/MRX select list box
Selects the MTX/MRX to which the PGM1 unit for which you want to make settings is
connected. The list box shows units in order of UNIT ID and the name of the MTX/
MRX.
● PGM1 select list box
Select the PGM1 unit for which you want to make settings. All PGM1 units that are
connected to the MTX/MRX selected in the MTX/MRX selection box are listed in
order of UNIT ID and the name of the PGM1 unit.
● [Unlatch Enable] check box
If this check box is selected, the PTT button of the selected PGM1 operates both as
latched and unlatched. If this check box is not selected, the PTT button operates as
latched.