User Manual

Workflow Chapter 1. An overview of MTX-MRX Editor
MTX-MRX Editor User Guide
22
Use the rear panel [UNIT ID] rotary switch and DIP switches to set the UNIT ID of each
device. In MTX-MRX Editor, the UNIT ID is shown as a hexadecimal number. Use the
DIP switches (switches 1–2 on the MTX/MRX and EXi8/EXo8, switches 1–3 on PGM1
and YDIF-equipped models of XMV) to specify the upper digit, and use the [UNIT ID]
rotary switch to specify the lower digit. On Dante-equipped models of XMV, use the
[UNIT ID] rotary switch [HIGH] to specify the upper digit, and use [LOW] to specify the
lower digit.
For details on the R series (AD/DA) or the Tio1608-D, refer to their respective owner’s
manuals.
Do not set the UNIT ID to 00.
Example setting) Setting the UNIT ID to [0A] on YDIF-equipped models of XMV
Use the DIP switch combinations shown below to specify the upper digit of the UNIT ID.
If you want to use a DHCP server or operate the device with a fixed IP address, refer to “IP
Address” dialog box. To open the “Set IP Address” dialog box, use the “Device Information”
dialog box which you can access from the [System] menu.

Upper digit is 0
Upper digit is 1
Upper digit is 2
Upper digit is 3
Upper digit is 4
Upper digit is 5
Upper digit is 6
Upper digit is 7
0A
DIP switch
[UNIT ID]
Rotary Switch
3
3
3
3
3
3
3
3
ON
3
3
3
3
3
3
3
3
ON
3
3
3
3
3
3
3
3
ON
3
3
3
3
3
3
3
3
ON
3
3
3
3
3
3
3
3
ON
3
3
3
3
3
3
3
3
ON
3
3
3
3
3
3
3
3
ON
3
3
3
3
3
3
3
3
ON
NOTE