User Manual

“Security Settings” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
228
❑ “Security Settings” dialog box
On the MTX/MRX system, you can specify a PIN code (numeric password) for security.
● [Security] check box
If this check box is selected, the “Security” dialog box will appear when the project file
starts.
If this check box is cleared, all users will be able to make changes in MTX-MRX Editor.
● [PIN Code]
If the [Security] check box is selected, enter the PIN code (four single-byte numerals).
You cannot enter anything other than single-byte numerals, nor can you enter a blank
PIN code.
• The PIN code can be viewed in this dialog box. Make sure that it is not seen by
another user.
• If you forget the PIN code, you will be unable to open the corresponding project file.
● [OK] button
Updates the settings and closes the dialog box.
If you are online, these settings will be transmitted to all MTX/MRX units in the
project.
If you are offline, they will be transmitted when you go online.
● [Cancel] button
Closes the dialog box without updating the settings.
“Security” dialog box
When you open a project file for which a PIN code has been specified, the “Security”
dialog box appears.
Enter the PIN code, and click the [OK] button.
NOTE