User Manual

List of settings in “Settings” dialog boxes Appendix
MTX-MRX Editor User Guide
239
If [Play all songs in a folder] is selected
Select the folder shown in [SD CARD:/]. Up to 100 songs saved in the currently
selected folder will play.
The following folder formats can be shown.
•(folder name)
•blank
- Only first-level folders are valid.
- If the folder name is blank, the songs that exist in the root level of the memory card
will be played (folders below the root level will not be included).
❍ [Play Mode] (only if parameter type is [SD Song Select & Play])
✦[Normal]/[Repeat]/[Shuffle Repeat]
This specifies the play mode for the song or songs.
If you choose [Normal], the specified song or songs in the folder will play once.
If you choose [Repeat], the specified song or songs in the folder will play repeatedly.
If you choose [Shuffle Repeat], the songs in the specified folder will play repeatedly in
random order. If you choose [Play 1 song] in [Folder/File], the [Shuffle Repeat]
setting will be unavailable.
✦[Go to the top when playback stops.]
When you stop song playback, this specifies whether the song will pause at the
location where you stopped or will return to the beginning of the song.
If this is on, playback will begin from the beginning of the song or the first song in the
folder the next time you start playback.
If this is off, playback will begin from the location at which you stopped the next time
you start playback.
● If [FUNCTION] is [Preset Recall] (switch only)
The preset specified by the switch will be recalled.
❍ [PARAMETER1]
Selects the preset number that will be recalled.
● If [FUNCTION] is [MTX Level] or [MTX Send Level]
In the case of Knob/Slider/MCP1
The knob, slider, or MCP1 switch controls the level or send level.
Select one of the following parameter types, and then make the appropriate setting.
In the case of MTX Level
•Input Ch Level
•Fx RTN Level
•Matrix Out Level
•ZONE Out Level
•Output Ch Level
•1st Priority Mix Level
•2nd Priority Mix Level
•Input Ch DCA Group
•ZONE Out DCA Group
If you want to control multiple input channels, use [Input Ch DCA Group] or [ZONE Out DCA
Group].
In the case of MTX Send Level
•Input Ch Send Level
•Fx RTN Send Level
NOTE
NOTE