User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
Digital control panel, PGM1/PGX1 Chapter 3. Project screen
MTX-MRX Editor User Guide
49
❑ Digital control panel, PGM1/PGX1
This area shows an illustration and panel ID for each of the digital control panel (DCP) units and
PGM1/PGX1 units assigned by the wizard. Up to eight DCP units can be connected to one MTX/
MRX unit.
Up to four PGM1 units can be connected to one MTX/MRX system. The PGM1 can control only
a single MTX5-D/MRX7-D unit. The left-most PGM1 is the 1st Priority Mic. For more about the
1st Priority Mic, refer to “ZONE” screen.
Digital Control Panel/PGM1 switching button
Selects whether to show the Digital Control Panel or the PGM1.
This is available when the [System] tab/[Device] tab/[Alert] tab is expanded.
List of connected devices
This shows the digital control panels and PGM1/PGX1 units that are connected to MTX/
MRX units in the MTX/MRX system.
If you double-click the graphic of a PGM1, an explanation of the device setting DIP
switches will be shown. If you double-click the graphic of a PGM1 when online, the
current setting of the DIP switches will be shown.
Identify button
When you click this, the indicator of the corresponding device will flash for approximately
five seconds, allowing you to identify the device.
Identify button
Digital Control Panel/PGM1 switching button
List of connected
devices