User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
Analog-connected devices Chapter 3. Project screen
MTX-MRX Editor User Guide
50
❑ Analog-connected devices
Of the devices controlled by MTX-MRX Editor, this area shows the devices whose audio signals are
connected via analog.
List of analog-connected devices
This shows the XMV units within the MTX/MRX system that are connected to the MTX/
MRX via an analog connection.
If you double-click the device graphic, a description of the device setting DIP switches will
appear. If you double-click the device graphic when MTX-MRX Editor has recognized a
device, the current settings both of the device setting DIP switches and of the [SPEAKERS]
DIP switches are shown. If you double-click the graphic of a device while online, the
current settings of the DIP switches are shown, allowing you to make HPF settings for each
channel.
Identify button
When you click this, the indicator of the corresponding device will flash for approximately
five seconds, allowing you to identify the device.
Scroll buttons
Use these to scroll the display up or down.
List of analog-
connected devices
Identify button
Scroll buttons