User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
Input channels Chapter 4. System screen
MTX-MRX Editor User Guide
62
Parameter edit screen (for the EXi8)
A
C
B
D
E
F
G
H
I
K
J
A Meter
Shows the input signal level.
B [+48V] button
Turns the HA phantom power (+48V) on/off.
Notice
Be sure to leave this button off if you do not need phantom power.
Follow the important precautions below, in order to prevent noise
and possible damage to external devices as well as the unit when
you operate this switch.
• Be sure to leave this button off when you connect a device that
does not support phantom power to [INPUT] connector.
• Do not connect/disconnect a cable to/from [INPUT] connector
while this button is on.
• Down the output level to the minimum before operating this
button.
There is no master switch. To avoid malfunctions, be sure to set
this appropriately for the equipment that is connected.
C [GAIN] knob
Adjusts the analog gain of the HA (head amp)
D HA analog gain
Shows the HA analog gain setting.
E [HPF] button
Switches the HPF (High Pass Filter) on/off.
F [Freq] knob
Specifies the cutoff frequency of the HPF.
G Cutoff frequency
Indicates the cutoff frequency of the HPF.
H [Ø] button
Switches the phase of the input signal.
I [ON] button
Switches the input channel on/off.
J Channel name
Indicates the channel name of the EXi8. You can double-click
this and edit it.
K Channel index
Indicates the number of the device’s input connector. If you
place the cursor here, a popup will show the UNIT ID and the
name of the external device.
NOTE