User Manual

“PRIORITY DUCKER” screen Chapter 4. System screen
MTX-MRX Editor User Guide
94
“PRIORITY DUCKER” screen
In this screen you can make ducker settings.
The ducker is a function that temporarily reduces the input from one channel when an
audio signal is input to another specified input channel, allowing the audio from the
specified channel to be heard clearly. The priority order is as follows: “PRIORITY
SOURCE” of the “1st PRIORITY” > “PRIORITY SOURCE” of the “2nd PRIORITY” >
MATRIX Out signal.
1 ZONE select buttons
Use the left and right buttons to select the zone for which to make settings.
The name of the zone is shown at the right.
You can also use the output channel [SEL] buttons to select a zone.
2 Graph and GR meter
This graph shows the ducker settings. The amount of gain reduction applied by the
ducker is shown at the right of the graph.
3 Ducker setting area
Ducker settings can be copied between 1st/2nd, or to
another zone.
When you right-click within the copy-source settings
area, a list will appear.
• DUCKER [ON] button
Turns the ducker on/off.
• [PRIORITY SOURCE] list
Selects the input signal for the ducker.
Select [ANC Bus] if you want the mixed signal to
be the high-priority audio. The mix of audio
signals to the ANC bus can be created in the
“MATRIX” screen.
•DUCKER indicator
When the ducker operates, the indicator will light green to indicate operation.
• [MIX LEVEL] knob
Adjusts the amount by which the signal selected in the [PRIORITY SOURCE] list
will be mixed into the ducker’s output.
•[THRESHOLD] knob
Specifies the threshold level at which the ducker will take effect.
1
2 3
NOTE
HINT
NOTE