User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
“PGM1/PGX1” dialog box
MRX Designer User Guide
131
❑ “PGM1/PGX1” dialog box
Here you can make assignments for the zone/message select buttons of the PGM1 or PGX1, and
make settings for the PTT button.
For details on the “PGM1/PGX1” dialog box, refer to “MTX-MRX Editor User Guide.”
❑ “Port Name” dialog box
If a port is selected, clicking the button located in the right side of the Label edit area in the
“Properties” area makes this appear.
Here you can edit all port names of the component that includes the selected port.
1 Component name
Indicates the component name of the component that includes the selected port.
2 [IN]/[OUT] fields
Show the default port names.
3 [Port Name] field
Shows or edits the port name. When you press <Enter>, the input is confirmed and the
focus moves to the next port. You can also use the cursor keys to move the focus.
4 [Set Default Name] button
Specifies the name that is shown in the [Port Name] fields of the [IN]/[OUT] areas.
5 [All Clear] button
Clears all port names.
6 [OK] button
Saves the settings and closes the dialog box.
7 [Cancel] button
Closes the dialog box without saving the changes.
3
1
4 5 6 7
2