User Manual

Appendix
MRX7-D Owner’s Manual
27
44
A timeout has occurred in synchronization
to the time server or the server reply is
invalid.
Check the time server condition or set another time server.
45
The host name of the time server can not
be resolved by DNS server.
Check the setting of the time server, DNS server address or make sure that the
DNS server works correctly.
46
Dante transmission flow count exceeded
the limit.
Maximum Dante Flow rate exceeded. Try changing parts of transmission flows to
Multicast using Dante Controller.
50 The UNIT ID is set to “00.” Set the UNIT ID to something other than “00.”
51
Devices with identical UNIT IDs were
found connected within the same net-
work.
Change the UNIT ID so that there are no duplicates.
52
A communication error occurred with the
[DCP] connection.
• If an error was shown in the DCP panel, refer to the DCP owner’s manual and
take the appropriate action.
• Ensure that the panel ID of the DCP units do not conflict.
• Verify that the cables are correctly connected and are within the specified length.
53
The DCP connected to the [DCP] connec-
tor has been configured differently from
the project settings.
• Check that the required DCP is connected.
• Check whether a different model of DCP might be connected.
56 SD memory card was not recognized. Use an SD memory card that complies with the specifications. (See page 28.)
58
Unable to play the specified file or folder
in the SD player.
Verify that the specified audio file or folder exists in the SD memory card. There
must be at least one playable audio file in the specified folder.
60
A preset/snapshot recall attempt has
failed.
Initialize the memory of the device. If this does not solve the problem, contact your
Yamaha dealer.
61
The recall could not be executed because
the preset to be recalled when the device
starts up was not found.
Specify a preset that exists. No sound will be output unless an appropriate preset
is recalled.
64
The preset/snapshot could not be
recalled.
• The Preset selected for recall cannot be recalled as no data has been stored to it.
• Another device may have been added after presets were stored. Please synchro-
nize and check all presets using MTX-MRX Editor, edit as necessary and store
again.
65 Invalid parameters are set for GPI IN. Check the GPI IN settings and perform synchronization again.
66 Invalid parameters are set for GPI OUT. Check the GPI OUT settings and perform synchronization again.
67 Invalid parameters are set for DCP[*]. Check the DCP[*] settings and perform synchronization again.
68
Invalid parameters are set for Wireless
DCP.
Check the Wireless DCP settings and perform synchronization again.
70
Synchronization has not been com-
pleted. It may be that synchronization was
halted before completion.
Perform synchronization again using MTX-MRX Editor. If this does not solve the
problem, initialize the memory of the device and synchronize again. If this also
fails, contact your Yamaha dealer.
71
The UNIT ID settings when synchroniza-
tion was performed do not match the cur-
rent UNIT ID settings.
Do not change any UNIT ID’s after performing synchronization. If you’ve changed
any UNIT ID’s, perform synchronization again.
72
Because this device has Dante Device
Lock enabled, the settings of device DIP
switches and MTX-MRX Editor do not
match current Dante settings.
If you have Dante Device Lock enabled, please disable using Dante Controller,
review device DIP switch settings and MTX-MRX Editor’s Dante settings, and edit
as necessary to match the current situation.
80 Speech Privacy Audio File is not installed. Install the Speech Privacy Audio File.
Alert
number
Meaning Response