User Manual

16 PGM1/PGX1 Installation Manual

Connecting a PGX1

Up to two PGX1 units can be connected to one PGM1 unit.

1. Turn the PGM1 and PGX1 units over on their back.

2. Place the PGM1 on the right, and place the PGX1 to be connected on the left.

3. Remove the rubber cap from the bottom panel of the PGM1.

4. Use the included connection cable to connect the PGM1 and PGX1.

5. Place the connecting bracket between the two units, and fasten the screws (at the 8

locations shown below) on the PGX1 side to secure it.

6. Place the rubber cap that you removed from PGM1 into the socket of the unused

dedicated 8-pin connector of the PGX1.

If you want to connect a second PGX1 unit, you can do so in a similar way.

NOTICE

• Before making connections, detach the Ethernet cable and gooseneck mic.

• Make sure to place a soft cloth underneath the device so that the surface of the body will not be

damaged.

PGX1 PGM1

Connecting bracket

PGX1 PGM1