User Manual

Yamaha Commercial Audio
Dante-MY16-AUD HA Remote Control Guide
14 www.yamahaproaudio.com
Note:
If the mixer cannot recognize HA equipment and the HA equipment does not
appear on the screen of the mixer, please check the following.
・ Are the Dante-MY16-AUD firmware and Dante Controller updated to a version
that supports the HA remote function? Firmware V3.3.9 or later and Dante
Controller V3.2.9 or later are required.
・ (In the case where a serial cable is used) Are you using a straight cable?
・ (In the case where control is done via the Mini-YGDAI slot) Have you inserted
the Dante-MY16-AUD in SLOT1? Those other than SLOT1 cannot transmit
HA control signals.
・ Is the HA Remote bridge mode of Dante-MY16-AUD set properly?
・ Is AD8HR mode set on the front panel of the R series? Are all the virtual unit
IDs unique to each other?
・ Ensure that a port other than REMOTE and SLOT1 is selected as a MIDI port
on the MIDI SETUP screen of the digital mixer.