User Manual

Table Of Contents

Dante Controller User Guide

-36-

n Product Version: The product version, as defined by the manufacturer

n Primary Address: The IP address assigned to the primary interface.

IP addresses are currently assigned via DHCP, or automatically self-assigned. Self-assigned

addresses on the primary interface will be in the 169.254.*.* range.

n Primary Link Speed: The Ethernet link speed of the primary interface

n Secondary Address: The IP address assigned to the secondary interface.

Self-assigned addresses on the secondary interface will be in the 172.31.*.* range. 'N/A'indicates

that the device does not support a secondary interface. 'Link down' indicates that the device sup-

ports a secondary Dante interface, but it is not currently connected.

n Secondary Link Speed: The Ethernet link speed of the secondary interface. Other values are pos-

sible (as per Secondary Address)

Note: A Dante interface may have a preferred link speed. Where it does, and an interface is not

operating at that preferred link speed, the values in the Link Speed columns will be shown in red.

Note: If no device information is displayed for a device, it can indicate a ConMon (Dante control and

monitoring service) failure on the device. The device may need to be reset or restored.

Clock Status

The Clock Status tab provides a network-wide overview of the clocking state within the network.

This view provides a convenient way of quickly scanning the network for clock information. The tabular

view presents the following information, in columns from the left:

Device Name

The device name currently associated with the device.

Sync

Indicates the clock sync status for the device.