User Manual
Table Of Contents
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Starting Dante Controller
- Using Dante Controller
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2014 Audinate Pty Ltd. All rights reserved.
-53-
device type in the Device Info tab.
n Connected To: Lists the Tx channel that the receive channel is currently subscribed to.
n Status: Shows the status of both primary and secondary subscriptions, using the following icons:
Subscription is OK and audio should be flowing
Subscription is unresolved - usually because the transmitting device
has been removed from the network, or is switched off
No subscription, or a subscription error
Subscription is via unicast connection
Subscription is via multicast connection
Subscriptions can show several symbols in the Status column. Common status icon combinations and
their meanings are as follows:
Unicast device successfully subscribed to a
transmitter
Redundant device successfully subscribed on
both primary and secondary via unicast
Redundant device successfully subscribed on
both primary and secondary via multicast
Redundant device successfully subscribed on
primary only via unicast. This is typically seen
when the secondary interface is not connected
Available Channels
The Available Channels pane lists the devices and advertised channels available on the network. Devices
that are greyed out indicate that this receiver cannot subscribe to those channels or devices. This is
typically because of a mismatch in parameters (e.g. sample rate incompatibility etc.), or because a device
cannot route audio to itself.
For devices with many channels, you can click the Channel Groups button to group available
channels into sets of 16.
Creating Subscriptions
Subscriptions are created by selecting a channel from the Available Channels list in the right-hand pane of
the Receive Tab, then dragging and dropping it onto the appropriate receive channel in the left-hand pane of
the Receive Tab.
Multiple channels can be selected and then dragged and dropped onto the Receive Channels pane, to
make several subscriptions simultaneously. You can also drag and drop channel groups to make bulk
subscriptions.
Changing Receive Channel Labels
To change a receive channel label, click the label and type in the new value.