User Manual
Table Of Contents
- Getting Started
- Main window
- Overview window
- Selected Channel window
- Library window
- Premium Rack Library window
- Patch Editor window
- Virtual Rack window
- Meter window
- Group/Link window
- Scene window
- Custom Fader Bank Setup window
- Custom Fader Bank window
- User Defined Keys Setup window
- User Defined Knobs Setup window
- Sends On Fader window
- Outport Setup window
- Keyboard Shortcuts
- Index
CL Editor Owner’s Manual
42
If DE-ESSER is selected
1 TYPE
This indicates that De-Esser is the currently selected type.
2 LIBRARY
This button accesses the dynamics library. Clicking this button will open the DYNAMICS page of the Library window.
3 ON
This button switches the de-esser on/off.
4 Response curve
Indicates the response for the de-esser of the currently selected channel.
5 GR meter (Gain Reduction meter)
This meter indicates the amount of gain reduction produced by the de-esser.
6 THRESH (Threshold level)
Specifies the threshold level at which the de-esser will operate. The input signal will start being compressed when the
key-in signal exceeds this level; compression will be removed when the signal falls below this level.
7 FREQ (Minimum frequency/Center frequency)
Specifies the minimum frequency (for HPF) or the center frequency (for BPF) at which the key-in signal will activate
the de-esser.
8 TYPE
Drag the knob in the screen to select the HPF (High Pass Filter) or BPF (Band Pass Filter.)
9 Q
Adjust the Q level of the frequency range at which the key-in signal will activate the de-esser.
This parameter is valid only if the TYPE is set to BPF.
0 KEY IN SOURCE
The key-in signal is set to the SELF POST EQ.
1
4
0
235
7
8
9
6