User Manual
Table Of Contents
- 1. Introduction
- 2. Conversion procedure
- 3. Reference
- 3.1. Conversion Options
- 3.2. Conversion between PM5D and M7CL
- 3.3. Conversion between PM5D and CL/QL
- 3.4. Conversion between M7CL and LS9
- 3.5. Conversion between M7CL and CL/QL
- 3.6. Conversion between LS9 and CL/QL
- 3.7. Conversion between RIVAGE PM and CL/QL
- 3.8. Conversion between RIVAGE PM and DM7
- 3.9. Conversion between CL/QL and DM7
- 3.10. “Recall Filter” Treatment
33
Input Channel
Output Channel
Global
Pre/Post
Surround
LCR
Mode Stereo, 5.1
LCR assignment
3.1, 6.1
LCR ratio
Surround
L,R,C,LFE,Ls,Rs ON
PAN
Divergence
LFE Level
<Key to table> : converted ! : Check optimizing logic below : not converted
*Notes
1) DYNAMICS parameters are converted when configurations match (see table below). DYNAMIC
parameters will be set to default values when the configurations do not match. RELEASE, HOLD,
DECAY parameters are converted to valid values when the RIVAGE PM or the DM7 is using 48
kHz Wordclock.
Dynamics2 -Input Channel / Dynamics1 -Output Channel
RIVAGE PM
LEGACY
COMP
COMP260
EXPANDER
GATE
DUCKING
DE-
ESSER
Other Types
DM7
LEGACY
COMP
COMP260
EXPANDER
GATE
DUCKING
DE-
ESSER
Comp260
<Key to table> Blue field and arrow means compatible setting
Orange field and arrow means setting replaced by substitution
2) KEY IN SOURCE is converted as shown in the table below.
Key In source -Input Channel
RIVAGE PM
Self Post EQ
Other Pre EQ
Other types
DM7
Self
Other Pre DYN1/Proc
Default
Key In Source -Output Channel
RIVAGE PM
Self Post EQ
Other types
DM7
Self
Default
3) Converts with RIVAGE PM Insert 1. When there is no same point in the convert destination, the
converter will substitute an appropriate value.
Insert Point -Input Channel
RIVAGE PM
Pre Filter
Pre DYN1
Pre Fader
Post On
Other types
DM7
Pre Filter
Pre DYN1
Pre Fader
Post On
Default
Insert Point -Output Channel
RIVAGE PM
Pre Filter
Pre Delay
Post Fader
Post On
Other types
DM7
Pre Filter
Pre Delay
Post Fader
Post On
Default
Direct Out Point -Input Channel
RIVAGE PM
Pre Filter
Pre DYN1
Pre Fader
Post Fader
Post On
Other types
DM7
Pre Filter
Pre DYN1
Pre Fader
Post Fader
Post On
Default
Delay Point -Input Channel
RIVAGE PM
Pre Filter
Pre DYN1
Pre Fader
Post Fader
Other types
DM7
Pre Filter
Pre DYN1
Pre Fader
Post Fader
Default
Mix to Stereo Point -Mix Channel
RIVAGE PM
Pre Filter
Pre Delay
Pre Fader
Post Fader
Post On
Other types
DM7
Pre Filter
Pre Delay
Pre Fader
Post Fader
Post On
Default
4) Reproducibility of Recall Safe & Focus Recall
Refer to section 3.10, “Recall Filter” Treatment.