User Manual

35
Input Channel
Output Channel
Global
LCR ratio

Surround
L,R,C,LFE,Ls,Rs ON

PAN

Divergence

LFE Level

<Key to table>  : converted ! : Check optimizing logic below  : not converted
*Notes
1) Channel colors are converted to colors which are similar.
2) ST IN of CL/QL are converted to DM7 paired channels.
3) CL/QL EQ settings are converted to DM7 EQ A settings. For output channel parameters, CL/QL
four-band EQ and DM7 EQ band 1, 2, 7, 8 are converted.
4) CL/QL DYNAMICS settings are converted to DM7 DYNAMICS A settings. Input DYNAMICS
parameters are converted when configurations match (see table below). CL/QL COMP are
converted to DM7 LEGACY COMP. DYNAMIC parameters are set to default values when the
configurations do not match. RELEASE, HOLD, DECAY parameters are converted to valid values
when the DM7 or the CL/QL is using 48 kHz Wordclock.
Dynamics1
CL/QL
GATE
DUCKING
COMP
EXPANDER
DM7
GATE
DUCKING
LEGACY
COMP
EXPANDER
Dynamics2
CL/QL
COMP
DE-ESSER
Other types
DM7
LEGACY
COMP
DE-ESSER
Off
<Key to table> Blue field and arrow means compatible setting
Orange field and arrow means setting replaced by substitution
5) KEY IN SOURCE is converted as shown in the table below.
CL/QL
Self Post EQ
Other types
DM7
Self
Default
6) When there is no same point in the convert destination, the converter will substitute an appropriate
value.
Insert Point -Input Channel
CL/QL
Pre Fader
Post On
Other types
DM7
Pre Fader
Post On
Default
Insert Point -Output Channel
CL/QL
Pre Fader
Post On
Other types
DM7
Pre Delay
Post On
Default
Direct Out Point -Input Channel
CL/QL
Pre HPF
Pre Fader
Post On
Other types
DM7
Pre Filter
Pre Fader
Post On
Default
7) Reproducibility of Recall Safe & Focus Recall
Refer to section 3.10, “Recall Filter” Treatment.