Manualshelf

User Manual

ManualsBrandsYamaha ManualsMixersDigital Mixing Console
21222324252627282930
Screen areas
User's Guide
TF StageMix
-
22
-
3 Fader
Drag the fader's knob up and down to adjust the fader level.
The fader stops at the nominal level (0dB); you can then continue to drag it up or down as desired.
You can drag the fader left and right and then up and down to adjust it more precisely.
You can adjust multiple faders at the same time.
4 Meter display
Displays the post-fader channel level.
Two meters are displayed for MONITOR channels and for channels linked as a stereo pair.
Meters are not displayed for DCA channels.
5 CUE button
Turns the channel's cue on and off. This button lights up when the cue is turned on.
The CUE button is not displayed for the MONITOR channel.
CH Name area
Allows you to adjust the channel's pan/balance, and displays the channel's number, name, icon, and color.
1 Pan/balance slider
Drag left and right to adjust the pan or balance of the channel.
The control stops at the center position; you can then continue to drag it left or right as desired.
When the pan or balance is set to the center position, a round icon is displayed. You can also double-tap this area to set the
pan or balance to the center position.
You can adjust pan/balance for multiple channels at the same time.
2 Channel display
Displays the channel number, name, icon, and color.
Overview strip area
The STEREO channel strip is normally displayed in the overview strip area. When using SENDS ON FADER mode, the destination
AUX channel, SUB channel, or MATRIX channel strip is displayed here.
You can switch to SENDS ON FADER mode by tapping a channel number displayed on the left side of the strip. The selected
channel will be highlighted in the channel's color. Tapping on OFF at the bottom or the selected channel number restores the regular
mode.
NOTE
• If you have adjusted the Fader/Pan Delay setting on the PREFERENCE screen (page 17), the fader value is displayed in light blue when
the fader can be adjusted.
• If Fader 0dB Detent on the PREFERENCE screen is turned off (page 17), the value fader does not stop at the nominal point.
ձ
ղ