User Manual

Screen areas
User's Guide
TF StageMix
- 20 -
Processing area
Displays each channel's EQ, INPUT, GATE, COMP, SEND TO, GEQ, SEND PAN (when using SENDS ON FADER mode), DELAY
and FX. The type of information displayed here varies depending on the type of channel. Tapping the processing area displays the
corresponding setting screen. (The Send Pan display does not have a corresponding setting screen, but the values can be changed
by sliding a finger over the icon.)
You can swipe left and right in this area to display other information. The type of information displayed in the processing area
changes for all channels.
The type of information that can be displayed in this area for each type of channel is explained below.
Fader area
Allows you to adjust the fader and cue for each channel.
1 ON button
Turns the channel on and off. This button lights when the channel is turned on.
It flashes when a mute group is turned on. Tap the button while it is flashing to turn the mute off.
Additionally, if a DCA channel is turned off, the ON button of channels included in the DCA channel flash. In this case, tapping
the button has no effect.
2 CUE button
Turns the channel's cue on and off. This button lights up when the cue is turned on.
The CUE button is not displayed for the MONITOR channel.
3 Fader
Drag the fader's knob up and down to adjust the fader level.
The fader stops at the nominal level (0dB); you can then continue to drag it up or down as desired.
You can drag the fader left and right and then up and down to adjust it more precisely.
You can adjust multiple faders at the same time.
CH 1–32 CH 33–40
ST IN
1L–2R
FX
1L–2R
DCA1–8 STEREO AUX1–8
AUX 9/10–
AUX 19/20
SUB MON MATRIX
Input
–
–––––––
EQ

–

–

Gate

––––––––––
Comp

––––

–
–
GEQ –––––

––––
Send Pan

–

––
Send To

–––––––
Delay ––

–––––––
FX –––FX1–FX2–––
InsFX1–
InsFX6
–––
NOTE
• When the MATRIX channel is set to "stereo", "Send Pan" will be displayed in STEREO AUX1-8, AUX9/10-19/20 and SUB.
• The "Display Delay Scale" setting in the General area of the PREFERENCE screen allows you to select the desired units (frames, meters, feet,
milliseconds) that are displayed in the MATRIX channel DELAY box. (page 16)
ձ
յ
ճ
մ
ղ