User Manual
Table Of Contents
9
TF series Quick Guide
Panels
1 OMNI OUT jacks
XLR-3-32 male output jacks that output analog audio
signals. These jacks are used mainly to output AUX
channels and STEREO channels. Nominal output level
is +4 dBu. You can select which signal is output on the
OMNI OUT screen.
2 ST IN jacks
Stereo input jacks that can be used for connecting a
CD player or other line level device. These jacks are
unbalanced female RCA jacks. Nominal input level is
-10 dBV.
3 INPUT jacks
Combination jacks that support both XLR and TRS
phone connectors. Use these jacks to connect mics
and instruments. Nominal input level is -62 dBu to +10
dBu. The head amp setting for each jack is saved in
memory.
4 NETWORK connector
RJ-45 jack used to connect the console to a
computer via an Ethernet cable (CAT5e or higher
recommended). Use STP (Shielded Twisted Pair) cable
to prevent electromagnetic interference.
5 USB TO HOST connector
USB connector used to connect the console to a
computer, allowing the console to function as an audio
interface. Supports input and output for 34 channels
of 48 kHz, 24-bit audio. When using with a computer
running Microsoft Windows, the Yamaha Steinberg
USB Driver is required. When using a Mac, Core Audio
is used and therefore no extra drivers are required.
6 FOOT SW jack
Used for connecting an optional FC5 foot switch. You
can use the connected foot switch as an effect bypass
switch, a mute switch, or use it to tap the delay time.
7 Expansion slot
Allows you to install an NY card, such as the NY64-D
Audio Interface Card.
(Installing an NY card → page 26)
8 Exhaust holes
The unit contains a built-in cooling fan. These holes are
used to expel air from the unit. To prevent overheating
or malfunction, do not block the exhaust holes.
9
Power switch
When the switch is in the
position, the power is on.
When the switch is in the
position, the power is off.
0 AC IN connector
Connect the included power cord. When connecting to a
power outlet, first connect the power cord to the console,
then connect the power cord to the power outlet.
CAUTION
• Make sure the unit is turned off before connecting
or disconnecting the power cord.
• Disconnect the power cord from the outlet when
the unit will not be used for extended periods of
time.
3-2 Rear panel
⑩ ⑨ ⑧
①
②
③
⑦ ⑥ ⑤ ④