User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 6 Tree View window
Amp Editor Owner’s Manual
112
Matching (Device Matching)
If devices are connected to the network, the devices in Amp Editor will normally be automatically matched with
the actual devices. If the Device ID or MAC addresses differ between the devices in Amp Editor and the actual
devices, the devices in Amp Editor and the actual devices must be manually matched. Matching must be done if
devices have been replaced due to a malfunction or other reason.
• The Device Matching function does not work with XMV units. Use a combination of the DIP switches
and [UNIT ID] rotary switch on the rear panel to match the UNIT ID.
1. Right-click the icon of a device in the Unmatched Device area.
2. From the context menu, choose [Device Matching...].
The “Device Matching” dialog box will appear.
3. From the devices shown in the “Device List,” select the device in Amp Editor that you
want to match.
4. Click the [OK] button.
The setting will be applied, and the dialog box will close. If you click the [Cancel] button, the dialog box
will close without applying the setting.
NOTE