User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 7 Detail View window
Amp Editor Owner’s Manual
126
Other
q Scene
Indicates the scene number and scene name.
w Amp Name
Indicates the name of the amplifier.
e [SLOT OUT] button (TXn only)
Click this button to open the “Slot Output” window.
In the “Slot Output” window you can monitor the slot output levels and the state of the output warning indica-
tors.
r [Signal Path View] button (TXn only)
Click this button to open the Signal Path View window (page 144).
t [STANDBY]/[ON] button
Monitors and controls the Standby/On status of the amplifier’s power supply.
Click the [STANDBY]/[ON] button to switch the power supply between Standby/On.
• If you switch amplifiers other than the XM/XH/XP from Standby to On, this button indicator will flash
yellow until the power to the amplifiers is turned on.
On :
Standby :
ewq rt
NOTE