User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 10 Component editor (TXn only)
Amp Editor Owner’s Manual
153
[Close All Editor Windows]
Closes all of the editor windows.
[Device Properties...]
Opens the Device Properties window (page 127).
The context menu in Design mode
Of the items in the Operation mode context menu, [Peak Hold] and [Level Meter Enable] are not shown.
Snap
This function temporarily memorizes the parameter settings of the component editor. When you click a snap but-
ton, all parameters of the editor will switch to the parameter set that was stored in that button. At this time, the
parameter set prior to this change will be stored in the snap button that had been selected before the switch. When
you recall a library item (page 155), the library item’s parameter set will be stored in the snap button that is
turned on at that time.
• The snap settings are not saved in the library or project folder. The snap settings will be discarded when
you exit Amp Editor or close the project.
• When you use the snap buttons to switch parameter sets, parameters for which local link is enabled will
change in tandem, but global link will not operate.
Snap buttons ([A]–[D] buttons)
These buttons switch parameter sets. The appearance of the button will change depending on their on/off state
and on whether there has been a change from the parameter set at the time the editor was started.
Buttons whose parameter set has not been modified since the editor was started
The button will light when you select it.
NOTE