User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 5 Main panel window
Amp Editor Owner’s Manual
35
Scene Link
This shows scene link information. By recalling a scene link, you can switch the scenes of multiple amplifiers in
a single action.
Scene link number / Scene link name
This shows the number and name of the last-recalled scene link.
[Change Scene Link] button
Click to [t] display a list from which you can select a scene link to recall. The selected scene link will be
recalled.
[Show/Hide Scene Link Manager] button
Opens the “Scene Link Manager” dialog box (page 89). In order to use scene link to recall the scenes of mul-
tiple amplifiers in a single operation, you must first register the scenes to be recalled as a scene link.
• The XMV does not support scenes.
SOLO (Solo Master)
You can enable or disable the solo function (Solo Master) for the workspace. When online, clicking the [SOLO]
button will display a confirmation dialog box, allowing you to enable or disable the function.
You can click [t] to access a list that lets you switch between Mix mode and Last mode. Select “Mix” if you
want to select multiple channels for solo output, or “Last” if you want only the last selected channel to be soloed.
• The XMV does not support the solo function.
: Enabled
: Disabled
Scene link number / Scene link name [Change Scene Link] button
[Show/Hide Scene Link Manager] button
NOTE
NOTE