User Manual

Marching Drum Carrier Owner's Manual

Make sure to install the frame to the instrument before mounting the instrument on the carrier.

1 Lay the marching bell & xylophone face down.

2 Use the supplied hexagonal wrench to loosen the screws A on the carrier frame so that the brackets can slide.

3 Set the carrier frame on the instrument, as shown in the illustration below, and slide the brackets on the

carrier frame so that they align with the carrier mounting plates on the bottom of the instrument.

4 Use the four fixing bolts B on the brackets to fix the carrier frame to the instrument. Tighten each of the

four bolts little by little in succession until they are secure.

5 Use the supplied hexagonal wrench to firmly tighten the screws A on the carrier frame.

NOTE • To remove the carrier frame from the instrument, loosen the four fixing bolts B.

• If you are having trouble re-installing the carrier frame after it has been removed, go through the

same procedure as described above.

1. Installing the frame to the instrument

Carrier frame

Carrier

mounting plate

Arm brackets

Hexagonal

wrench

Hexagonal

wrench

Brackets with

wing bolts

Setting the Marching Bell & Xylophone