User Manual

13
The head is made from consumable material, and may need to be replaced to prevent malfunction when partial discolor-
ation, sagging, fraying, tearing, or scraping appears. For information on replacement parts, contact your dealer or qualified
Yamaha service personnel.
1. Remove all six drum key bolts using the drum key.
The drum key can be found in the pad set package.
2. Remove the hoop.
3. Remove the old head, and then replace it with the new one. (The head can be installed in any direction.)
4. Attach the hoop, and then temporarily fix it with the drum key bolts.
5. Adjust the head tension.
Refer to the “Adjusting the Head Tension” (on page 12).
6. Apply a new patch so that the beater hits the center of the patch.
The head replacement is now complete.
Replacing the Head
• Do not touch the sensor unit, to avoid causing damage to the parts.
• If the kick pad is used without a patch, the head and beater will wear out faster and may cause damage.
Head
Drum key bolt
Hoop
Sensor unit
Loosen
Tighten