Service manual

CARB
REED VALVE
6-9
2. Measure:
• valve stopper height 
Out of specification

Adjust the stop-
per/Replace the valve stopper.
3. Measure:
• clearance of reed valve 
Out of specification

Replace the reed
valve.
INSTALLING THE REED VALVE
When the reed valve assembly is installed,
reverse the removal procedure. Bear in mind
the following points.
1. Install:
• gasket
2. Tighten:
• tighten the bolts for reed valve
NOTE:
Tighten each bolt gradually to avoid it being
deformed.
Height of valve stopper 
6.0 ~ 6.4 mm
Clearance of reed valve 
Less than 0.2 mm
Reed valve
11 Nm (1.1 m • kg)
New