Service manual

GEN
INFO
1 - 7
IMPORTANT INFORMATION
EAS00023
LOCK WASHERS/PLATES AND COTTER
PINS
After removal, replace all lock washers/
plates 1 and cotter pins. After the bolt or
nut has been tightened to specification,
bend the lock washer tabs and the cotter
pin ends along a flat of the bolt or nut.
EAS00024
BEARINGS AND OIL SEALS
1. Install bearings and oil seals so that the
manufacturer’s marks or numbers are
visible. When installing oil seals, lubri-
cate the oil seal lips with a light coat of
lithium soap base grease. Oil bearings
liberally when installing, if appropriate.
1 Oil seal
ACHTUNG:
CAUTION:
Do not spin bearings with compressed air
because this will damage the bearing sur-
faces.
1 Bearing
EAS00025
CIRCLIPS
Before reassembly, check all circlips care-
fully and replace damaged or distorted cir-
clips. Always replace piston pin clips after
one use. When installing a circlip 1, make
sure the sharp-edged corner 2 is posi-
tioned opposite the thrust 3 that the circlip
receives.
4 Shaft
1