Service manual
4 - 27
CHAS
FRONT AND REAR BRAKES
EAS00583
REPLACING THE REAR BRAKE PADS
NOTE:
When replacing the brake pads, it is not
necessary to disconnect the brake hose or
disassemble the brake caliper.
1. Remove:
• brake caliper
1
• brake pad cover
2
2. Remove:
• brake pad clips
1
• brake pad pins
2
• brake pad spring
3
3. Remove:
• brake pads
1
4. Measure:
• brake pad thickness a
Out of specification → Replace the brake
pads as a set.
Minimum brake pad thickness
0.5 mm (0.02 in)
5. Install:
• brake pads
• brake pad spring
NOTE:
Always install new brake pads and a brake
pad spring as a set.
▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼
a. Connect a clear plastic hose
1 tightly to
the bleed screw
2. Put the other end of
the hose into an open container.
4