Service manual

5 - 70
ENG
CLUTCH
EAS00296
INSTALLING THE CLUTCH
1. Install:
• dowel pin 1
• oil pump drive gear 2
• plate 3
• circlip 4
2. Install:
• clutch housing 1
• thrust washer 2
NOTE:
• Lubricate the clutch housing bearings
with engine oil.
• Make sure that the primary driven gear
teeth and primary drive gear teeth mesh
correctly.
• Make sure that the oil pump drive gear
teeth and oil pump driven gear teeth
mesh correctly.
3. Install:
• clutch boss assembly 1
NOTE:
• If the wire circlip 2 has been removed,
carefully install a new one.
• Install the clutch damper spring 3 with
the “OUTSIDE” mark facing out.
4. Install:
• clutch boss 1
• lock washer
• clutch boss nut 2
NOTE:
While holding the clutch boss with the uni-
versal clutch holder 3, tighten the clutch
boss nut.
New
T
R
.
.
70 Nm (7.0 m · kg, 50 ft · lb)
5