Service manual

5 - 80
ENG
GENERATOR AND STARTER CLUTCH
EAS00347
REMOVING THE GENERATOR
1. Remove:
• generator cover 1
NOTE:
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern. After all
of the bolts are fully loosened, remove
them.
2. Remove:
• generator rotor bolt 1
• washer
NOTE:
While holding the generator rotor 2 with
the sheave holder 3, loosen the generator
rotor bolt.
Sheave holder
YS-01880
3. Remove:
• generator rotor 1
(with the rotor puller 2)
Rotor puller
YM-01080-A
EAS00348
CHECKING THE STARTER CLUTCH
1. Check:
• starter clutch idle gears 1
• starter clutch gear 2
Chips/pitting/roughness/wear → Replace
the defective part(s).
2. Check:
• starter clutch operation
▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼
a. Install the starter clutch gear 1 onto the
starter clutch and hold the starter clutch.
b. When turning the starter clutch gear
clockwise Å, the starter clutch and the
starter clutch gear should engage, other-
wise the starter clutch is faulty and must
be replaced.
5