Service manual

5 - 94
ENG
TRANSFER GEAR CASE
3. Install:
• pins 1
• oil pump cover 2
NOTE:
Apply locking agent (LOCTITE

) to the
threads of the oil pump cover screws.
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)
4. Check:
• oil pump operation
Refer to “CHECKING THE OIL PUMP”.
INSTALLING THE TRANSFER GEAR CASE
1. Install:
• bearings
• oil seal
2. Install:
• middle driven shaft 1
• middle drive gear 2
• primary chain 3
(into the transfer gear case)
• O-ring
• spacer
• drive pulley nut 4
NOTE:
• Install the middle driven shaft, middle
drive gear and primary chain at the same
time.
• Temporarily install the drive pulley nut
onto the middle driven shaft.
3. Install:
• oil strainer 1
• dowel pins 2
• transfer gear case cover gasket 3
New
5