Service manual

2 - 20
SPEC
HINWEIS:
NOTE:
*1: When installing the crankcase stud bolts (cylinder head), make sure that their installed
length is 140.5 ~ 142.5 mm (5.53 ~ 5.61 in).
*2: When installing the crankcase stud bolts (transfer gear case), make sure that their
installed length is 68.3 ~ 70.3 mm (2.69 ~ 2.77 in).
Generator rotor Bolt M12 1 160 16.0 115
Generator shaft Bolt M8 1 28 2.8 20
LT
Pickup coil rotor Bolt M12 1 115 11.5 85
LT
Baffle plate Bolt M6 4 10 1.0 7.2
LT
Clutch boss Nut M20 1 70 7.0 50
Use a lock
washer.
Clutch spring plate Bolt M6 6 8 0.8 5.8
Pull lever Bolt M6 1 10 1.0 7.2
Transfer gear oil drain bolt – M8 1 18 1.8 13
Middle drive gear Nut M22 1 85 8.5 61
Use a lock
washer.
Transfer gear case Bolt M8 4 30 3.0 22
Transfer gear case Nut M8 1 30 3.0 22
Transfer gear oil checking bolt – M6 1 8 0.8 5.8
Transfer gear oil pump cover Screw M6 2 7 0.7 5.1
LT
Transfer gear oil pump Bolt M6 5 10 1.0 7.2
LT
Drive pulley case Bolt M8 7 30 3.0 22
Drive pulley Nut M22 1 85 8.5 61
Use a lock
washer.
Drive pulley cover bracket Bolt M8 2 30 3.0 22
Shift arm Bolt M6 1 10 1.0 7.2
Shift rod locknut – M8 2 12 1.2 8.7
Shift shaft spring stopper
Bolt M8 1 22 2.2 16
LT
Stopper lever Bolt M6 1 10 1.0 7.2
LT
Neutral switch Screw M6 2 7 0.7 5.1
Item Fastener Thread size Q’ty
Tightening torque
Remarks
Nm m·kgf ft·lb
TIGHTENING TORQUES
2