Service manual
7 - 41
–+
ELEC
SIGNALING SYSTEM
EB806411
2. A tail/brake light fails to come on.
YES
NO
1.Tail/brake light bulb and socket
• Check the tail/brake light bulb and socket
for continuity.
Refer to “CHECKING THE BULBS AND
BULB SOCKETS”.
• Are the tail/brake light bulb and socket
OK?
Replace the tail/
brake light bulb,
socket or both.
YES
NO
2.Brake light switches
• Check the brake light switches for conti-
nuity.
Refer to “CHECKING THE SWITCHES”.
• Is the brake light switch OK?
Replace the brake
light switch.
3.Voltage
• Connect the pocket tester (DC 20 V) to
the tail/brake light coupler (wire harness
side) as shown.
Tester positive probe → yellow 1
Tester negative probe → black 2
YES
NO
• Set the main switch to “ON”.
• Pull in the brake lever or push down on
the brake pedal.
• Measure the voltage (12 V) of yellow at
the tail/brake light coupler (wire harness
side).
• Is the voltage within specification?
This circuit is OK. The wiring circuit
from the main
switch to the tail/
brake light coupler
is faulty and must
be repaired.
EB806413
3. A turn signal light, turn signal indicator
light or both fail to blink.
YES
NO
1.Turn signal light bulb and socket
• Check the turn signal light bulb and
socket for continuity.
Refer to “CHECKING THE BULBS AND
BULB SOCKETS”.
• Are the turn signal light bulb and socket
OK?
Replace the turn
signal light bulb,
socket or both.
YES
NO
2.Turn signal indicator light bulb and socket
• Check the turn signal indicator light bulb
and socket for continuity.
Refer to “CHECKING THE BULBS AND
BULB SOCKETS”.
• Is the turn signal indicator light bulb and
socket OK?
Replace the turn sig-
nal indicator light
bulb, socket or both.
7