Service manual

7 - 42
–+
ELEC
SIGNALING SYSTEM
YES
NO
YES
NO
3.Turn signal switch
• Check the turn signal switch for continu-
ity.
Refer to “CHECKING THE SWITCHES”.
• Is the turn signal switch OK?
Replace the left han-
dlebar switch.
4.Voltage
• Connect the pocket tester (DC 20 V) to
the turn signal relay coupler as shown.
Tester positive probe → brown 1
Tester negative probe → ground
• Set the main switch to “ON”.
• Measure the voltage (12 V) of brown 1
at the turn signal relay coupler.
• Is the voltage within specification?
The wiring circuit
from the main
switch to the turn
signal relay coupler
is faulty and must
be repaired.
5.Voltage
• Connect the pocket tester (DC 20 V) to
the turn signal relay coupler as shown.
Tester positive probe → brown/white 1
Tester negative probe → ground
YES
NO
• Set the main switch to “ON”.
• Set the turn signal switch to “ ” or “ ”.
• Measure the voltage (12 V) of brown/
white at the turn signal relay coupler.
• Is the voltage within specification?
The turn signal
relay is faulty and
must be replaced.
6.Voltage
• Connect the pocket tester (DC 20 V) to
the turn signal light connectors (wire
harness side) or the meter assembly
coupler as shown.
Å Turn signal light
ı Turn signal indicator light
Left turn signal light
Tester positive probe → chocolate 1
Tester negative probe → ground
Right turn signal light
Tester positive probe → dark green 2
Tester negative probe → ground
Å
7