Service manual

3 - 11
CHK
ADJ
10.Adjust:
• valve clearance
▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼
a. Loosen the locknut 1.
b. Insert a thickness gauge 2 between the
end of the adjusting screw and the valve tip.
c. Turn the adjusting screw 3 in direction
a or b until the specified valve clear-
ance is obtained.
d. Hold the adjusting screw to prevent it
from moving and tighten the locknut to
specification.
e. Measure the valve clearance again.
f. If the valve clearance is still out of speci-
fication, repeat all of the valve clearance
adjustment steps until the specified
clearance is obtained.
▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲
11.Install:
• all removed parts
NOTE:
For installation, reverse the removal proce-
dure. Note the following points.
Refer to “ROCKER ARMS, PUSH RODS
AND VALVE LIFTERS” in chapter 5.
12.Adjust:
• installed shift rod length
Refer to “ADJUSTING THE SHIFT
PEDAL”.
Adjusting
screw side
Slip side
Direction a
Valve clear-
ance is
increased.
Valve clear-
ance is
decreased.
Direction b
Valve clear-
ance is
decreased.
Valve clear-
ance is
increased.
T
R
.
.
Locknut
20 Nm (2.0 m • kg, 14 ft • lb)
ADJUSTING THE VALVE CLEARANCE
3