Service manual
3 - 26
CHK
ADJ
MEASURING THE ENGINE OIL PRESSURE/
CHECKING THE TRANSFER GEAR OIL LEVEL
Out of specification → Adjust.
6. Install:
• oil gallery bolt
Engine oil pressure Possible causes
Below specification
• Faulty oil pump
• Clogged oil filter
• Leaking oil pas-
sage
Broken or damaged
oil seal
Above specification
• Leaking oil pas-
sage
• Faulty oil filter
• Oil viscosity too
high
T
R
.
.
20 Nm (2.0 m · kg, 14 ft · lb)
CHECKING THE TRANSFER GEAR OIL
LEVEL
1. Stand the motorcycle on a level surface.
NOTE:
• Place the motorcycle on a suitable stand.
• Make sure the motorcycle is upright.
2. Remove:
• checking bolt 1
3. Check:
• transfer gear oil level
The transfer gear oil level should be up
to the brim 1 of the hole.
Below the brim → Add the recom-
mended transfer gear oil to the proper
level.
Recommended oil
SAE80API “GL-4” Hypoid gear oil
3