Service manual

3 - 41
CHK
ADJ
ADJUSTING THE DRIVE BELT SLACK/
CHECKING AND ADJUSTING THE STEERING HEAD
a. Loosen the brake caliper bracket bolt 1.
b. Loosen the wheel axle nut 2.
c. Loosen both locknuts 3.
Å Right ı Left
d. Turn both adjusting bolts 4 in direction
a or b until the specified drive chain
slack is obtained.
NOTE:
To maintain the proper wheel alignment,
adjust both sides evenly.
e. Tighten both locknuts to specification.
f. Tighten the wheel axle nut to
specification.
g. Tighten the brake caliper bracket bolt to
specification.
▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲
EAS00146
CHECKING AND ADJUSTING THE
STEERING HEAD
1. Stand the motorcycle on a level surface.
WARNING
WARNING
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
Place the motorcycle on a suitable stand so
that the front wheel is elevated.
Direction a
Drive belt slack is
reduced.
Direction b
Drive belt slack is
increased.
T
R
.
.
Locknut
32 Nm (3.2 m • kg, 23 ft • lb)
T
R
.
.
Wheel axle nut
150 Nm (15.0 m • kg, 110 ft • lb)
T
R
.
.
Brake caliper bracket bolt
40 Nm (4.0 m • kg, 29 ft • lb)
Å
ı
3