Owner's Manual

8-12
EBU01099
Engine oil
Engine oil level measurement
1. Remove panel F. (See page 8-11 for
panel removal and installation proce-
dures.)
2. Place the ATV on a level surface and
warm up the engine for several minutes.
3. Stop the engine.
4. Remove the engine oil filler cap and wipe
off the dipstick with a clean rag.
5. Insert the dipstick in the filler hole without
screwing it in.
1. Engine oil filler cap
NOTE:
_
Wait a few minutes until the oil level settles
before checking.
_
6. The oil level should be between the max-
imum and minimum marks. If the level is
low, fill the engine with sufficient oil to
reach the specified level.
1. Maximum level mark 2. Minimum level mark
U5TE10.book Page 12 Wednesday, April 10, 2002 10:32 AM