Owner's Manual

8-28
a. Spark plug gap
2. Clean the gasket surface. Wipe off any
grime from the threads.
3. Install the spark plug and tighten it to the
specified torque.
NOTE:
_
If a torque wrench is not available when you
are installing a spark plug, a good estimate of
the correct torque is 1/4 to 1/2 turn past finger
tight. Have the spark plug tightened to the
specified torque as soon as possible.
_
4. Install the spark plug cap.
5. Install the panel.
Tightening torque:
Spark plug:
ft·lbf)
U5TE10.book Page 28 Wednesday, April 10, 2002 10:32 AM