Owner's Manual

4-5
EBU00053
Handlebar switches
1. Light switch “ //OFF”
2. Engine stop switch “”/“”
3. Start switch “”
EBU01204
Light switch “ //OFF”
Set the switch to “” to turn on the low beam
Set the switch to “” to turn on the high
beam and the taillight.
Set the switch to “OFF” to turn off all the lights.
CAUTION:
_
Do not use the headlights with the engine
turned off for more than thirty minutes.
The battery may discharge to the point
that the starter motor will not operate
properly. If this should happen, remove
the battery and recharge it.
_
EBU00849
Engine stop switch “”/“”
Make sure that the engine stop switch is in the
“” position. The engine stop switch controls
ignition and can be used at all times to stop
the engine, especially in an emergency. The
engine will not start or run when the engine
stop switch is turned to “”.
U5TE10.book Page 5 Wednesday, April 10, 2002 10:32 AM