User Manual

EN 11
Because the bridge includes a built-in pickup, which is connected to the body with a thin
cable, the instrument ships from the factory with the bridge laying down. First, set up the
bridge and then proceed with tuning. As the strings get old, sound quality will gradually
decrease, and it will become difficult to tune the instrument. Change the strings as soon as
you think they are getting old.
• The lower side of the bridge supports the 1st
string (E), the higher side supports the 4th string
(G). Please note the bridge orientation and cen-
ter the bridge over the pickup cable hole as
shown in the illustration below.
• Ensure that the bridge stands vertically. If it leans to one side, use both hands to adjust. Make sure
that each string passes over the corresponding grooves in the bridge.
WARNING
• The ends of the strings are sharp and can cut fingers. Use caution when changing strings.
• When changing or adjusting strings, do not put your face close to the instrument. The string may
suddenly break resulting in eye or other unexpected injuries.
Tuning and Changing the Strings
1st string
G
D
A
E
4th string
Pickup cable
Groove
Pickup cable
Bridge Hole
* The illustrations show
the view looking from
the tailpiece.
Place the bridge vertically.
Correct
Wrong Wrong
Tailpiece
Ver tical
Body