User Manual

81
Registration Memory
6
STOP: Selects the last registration and quits the operation.
TOP: After reaching the last preset, then selects the first preset
again and repeats the operation.
NEXT SONG: After reaching the last preset, then calls up the
registration data of the next song. This function is handy for you
to play a song containing more than 16 registrations.
Recording the songs onto the M.D.R. using this function allows
you to play back them successively.
NOTE:
Always press the PLAY button to start
the songs and activate this function on
the M.D.R. The CUSTOM PLAY button
will not cause to activate the Next Song
function.
NOTE:
Using the Next Song function will not
read the User voices, and the User
rhythm patterns/sequences while playing
back a rhythm.
Shift End mark
3. Press the Page buttons to select the EDIT page.
The Edit page appears.
There are two pages in the User mode: Mode and Edit.
Select the Edit page to program the desired sequence.
EDIT Page
1
-2
1
-1
1
-3
1
-4
12
2
-1
2
-3
2
-2
2
-4
PAGE
1 POSITION (Cursor Controls)
The cursor controls are used to move the cursor (the arrow in the
display) along the registration row in the display. Entered
registration numbers are shown in boxes, while the numbers in
the row above indicate the number of successive presses of the
Right Footswitch.
Move the cursor to the point you wish to edit.
1
-1
|<< Moves the cursor to the first position.
1
-2
< Moves the cursor one step to the left.
1
-3
> Moves the cursor one step to the right.
1
-4
>>| Moves the cursor to the last position.
NOTE:
The cursor cannot be moved unless
registration numbers have been entered.
NOTE:
Though about 15 Registration Shift steps
are shown in the display at one time, up
to 80 steps can be memorized; use the
cursor controls to access the undisplayed
steps.
NOTE:
The Shift End (see above) mark cannot
be moved using the cursor controls.
NOTE:
The Shift End mark ( for Top and for
Next Song) will automatically be put at
the end of the registrations you entered
when TOP or NEXT SONG is selected as
the Shift End on the Mode page.
2 DATA (Data Controls)
The data controls are used to enter and delete registration
numbers in the registration row. Move the cursor to the desired
position and edit the registration data.
2
-1
SET
For initially entering a registration number to a blank space in the
registration row, or for replacing a number at the current cursor
position. To enter a number, press the desired Registration
Memory button (the selected button will light), then press the
Data Control button corresponding to SET. After using SET to
enter registrations, the cursor can be moved among the numbers.
NOTE:
In the case of the EL-500 the registration
numbers from 9 through 16 are shown
in the dashed line-boxes.