User Manual
87
Music Disk Recorder
7
3
Recording
1) To record a song:
1
Set the desired registrations on the Electone.
Make all the Electone settings necessary for the song
you will record. This means entering the all
registrations you will need for the entire performance in
the Registration Memory. Make sure also to select the
registration that you will use at the beginning of the
song.
5
Press the PLAY button.
The PLAY lamp lights up and small bars flash across the
LED display from left to right, indicating that the
M.D.R. is reading the registrations and other settings.
PAUSE STOP PLAY SONG SELECT RECORD
UPPER LOWER PEDAL CONTROL UPPER LOWER PEDAL CONTROL
CUSTOM PLAY
SHIFT
RECORD PLAY
FORMAT
SONG
REPEAT
FROM SONG DEL.
SONG COPY
TO
MUSIC DISK RECORDER
TEMPO +–
--
NOTE:
If the selected song number already contains recorded
data, small bars (“--”) appear at the left part of LED
display and flash along with the song number, warning
you that the selected song number already contains
recorded data. If you want to execute recording
operation over the song number, press the RECORD
button again. If you don’t want, select another song
number for recording or press the STOP button to
cancel recording.
PAUSE STOP PLAY SONG SELECT RECORD
UPPER LOWER PEDAL CONTROL UPPER LOWER PEDAL CONTROL
CUSTOM PLAY
SHIFT
RECORD PLAY
FORMAT
SONG
REPEAT
FROM SONG DEL.
SONG COPY
TO
MUSIC DISK RECORDER
TEMPO +–
01
PAUSE STOP PLAY SONG SELECT RECORD
UPPER LOWER PEDAL CONTROL UPPER LOWER PEDAL CONTROL
CUSTOM PLAY
SHIFT
RECORD PLAY
FORMAT
SONG
REPEAT
FROM SONG DEL.
SONG COPY
TO
MUSIC DISK RECORDER
TEMPO +–
01
NOTE:
The song numbers 01 through 40 are available and up
to 40 songs can be stored on a disk. However, available
song numbers may be reduced depending on the
amount of the song data you have recorded. See page
105 for the information about the total amount of
memory left on a floppy disk.
2
Put a formatted disk into the disk slot.
3
Use the SONG SELECT (˝, Ó) buttons to select the
song number for recording. You can also select the song
number by pressing the Data Control buttons.
4
Press the RECORD button.
The RECORD lamp lights up and the PLAY and
CUSTOM PLAY lamps begins blinking, indicating that
the Music Disk Recorder is ready to record.