User Manual

Scene memory
Reference Manual
91
5. To enable Recall Safe for the selected channel, turn on the SAFE button in the SAFE
PARAMETER SELECT field. (If you have selected a DCA group, turn on either the
LEVEL/ON button or the ALL button.)
Channels or DCA groups for which Recall Safe is enabled will be highlighted in the CH RECALL
SAFE field.
6. To turn on Recall Safe for global parameters, press the GLOBAL RECALL SAFE field
to access the GLOBAL RECALL SAFE popup window, and turn on the appropriate
buttons.
These buttons correspond to the following parameters.
NOTE
If a dual-type GEQ rack or Premium Rack has been selected, you can apply Recall Safe to rack
A and B individually. For other racks, the Recall Safe setting for racks A and B will be linked.
7. When you have finished making settings, press the CLOSE button to close the
popup window. Then perform a Recall operation.
Only the selected DCA group channels and parameters will be excluded from Recall operations.
Bus settings are not subject to Recall Safe. They will always be reproduced in the recalled scene.
This means that if Recall Safe is enabled for one of several channels included in a link group or
one of two channels set to stereo, the parameter settings of that channel may differ from those of
the other channel(s). In such cases, the applicable parameter will be automatically re-linked the
next time it is operated.
You can globally apply Recall Safe to channel links by using the global parameter.
NOTE
• You can use the Recall Safe function along with the Focus function (see page 87). Channels or
parameters that are excluded from Recall operations by either Focus or Recall Safe will not be
recalled.
• If you hold down the [SEL] key while performing a recall operation, all parameters of that channel
will be treated as Recall Safe regardless of the state of the SAFE PARAMETER SELECT
selections.
Using the Fade function
“Fade” is a function that smoothly changes the faders of specified channels and DCA groups to their
new values over a specified duration when you recall a scene. The settings of the Fade function are made
independently for each scene.
1. Press the SCENE field in the Function Access Area.
The SCENE LIST window will appear, in which you can perform various operations for scene
memory.
2. Press the FADE TIME tab at the bottom of the SCENE LIST window.
The FADE TIME field is shown in the right half of the SCENE LIST window.
1 SET popup button
Press this button to open the FADE TIME popup window, in which you can select a channel for
which you want to use the Fade function, and specify the fade time (the duration of time over
which the fader will reach its new value).
2 FADER button
Enables or disables the Fade function for each scene.
INPUT PATCH
All input channel patching (including INSERT IN/OUT and DIRECT OUT
patching)
INPUT NAME All input channel names, icons, and channel colors
OUTPUT PATCH All output channel patching (including INSERT IN/OUT patching)
OUTPUT NAME All output channel names, icons, and channel colors
HA All I/O devices, and HA-related parameters for external head amps
CH LINK All channel link group settings
GEQ RACK
EFFECT RACK
PREMIUM RACK
Apply Recall Safe to GEQ racks 1–16, Effect racks 1–8, Premium Racks
1–8 individually.
PANEL SNAPSHOT
Fader bank selections, GAIN/PAN/ASSIGN knob selection status (set in
units of blocks)
2
1
3
4