User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-8-
Fanout 99
About Transmit Flows 99
Messages on Startup 99
Computer Configuration Checklist 100
Third-party firewall configuration 100
Troubleshooting Dante IP Address Configuration 100
Correct IP configuration 101
Possible IP network configuration mistakes 101
Incorrect PC/Mac IP configuration 101
Incorrect general IP configuration 101
Incorrect redundant network configuration 101
What are the symptoms of using the wrong network interface on my computer? 102
How do I check which network interfaces Dante Controller is using? 102
How do I check IP addresses for all devices on my network? 102
Troubleshooting Switch Configuration and Cabling 103
Symptoms of switch or cabling issues 103
Switch and Cabling Checklist 103
Index 104