Owner`s manual

Components
33
EMU35160
Power trim and tilt switches (twin
type)
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch “ ” (up) trims the
outboard motor up, and then tilts it up. Press-
ing the switch “ ” (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position.
 On the twin engine control, the switch on
the control grip controls both outboard mo-
tors at the same time.
 For instructions on using the power trim
and tilt switches, see pages 64 and 66.
EMU26244
Trim tab with anode
WARNING
EWM00840
An improperly adjusted trim tab could
cause difficult steering. Always test run
after the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
If the boat tends to veer to the left (port side),
turn the trim tab rear end to the port side “A”
in the figure. If the boat tends to veer to the
right (starboard side), turn the trim tab end to
the starboard side “B” in the figure.
NOTICE
ECM00840
The trim tab also serves as an anode to
protect the engine from electrochemical
corrosion. Never paint the trim tab as it
will become ineffective as an anode.
1. Power trim and tilt switch
1. Power trim and tilt switch
UP
DN
1
ZMU07151
UP
DN
11
1
UP
DN
ZMU05835
1. Trim tab
2. Bolt
3. Cap
3
2
1
ZMU07152
6CE-9-34-1E0.book 33 ページ ２０１２年１１月２３日 金曜日 午後１時１３分