Owner`s manual

Operation
54
EMU41770
Controls
 Turn the main switch “ ” (on) and make
sure that the Digital electronic control-ac-
tive indicator comes on.
 Turn the steering wheel full-right and full-
left. Make sure operation is smooth and
unrestricted throughout the whole range
with no binding or excessive free play.
 Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
EMU40362
Engine shut-off cord (lanyard)
Check the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
EMU40993
Engine oil
1. Place the outboard motor in a vertical
position (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01861]
2. Remove the oil dipstick and wipe it
clean.
3. Insert the oil dipstick completely and re-
move it again.
4. Check that the oil level on the oil dipstick
is between the upper and lower marks.
Consult your Yamaha dealer if the oil
level is not at the proper level or if it ap-
pears milky or dirty.
1. Fuel filter
1
ZMU07518
1. Clip
2. Engine shut-off cord (lanyard)
1. Oil dipstick
ZMU06873
1
2
1
ZMU07157
6CE-9-34-1E0.book 54 ページ ２０１２年１１月２３日 金曜日 午後１時１３分