Owner`s manual

Operation
60
ously for more than 5 seconds, the
battery will be quickly discharged,
thus making it impossible to start the
engine. The starter can also be dam-
aged. If the engine will not start after
5 seconds of cranking, return the
main switch to “ ” (on), wait 10 sec-
onds, then crank the engine again.
[ECM00192]
When starting the engine using the
Start/Stop button, press the button to
start the engine. The indicator for the
starting engine will come on.
When starting the engine using the
Start/Stop button on the All Start/Stop
switch panel, press the button to start
the all engines.
TIP:
 When the main switch is turned to “ ”
(start) with the clip removed from the en-
gine shut-off switch, the buzzer will sound.
 For twin type, if the clip is removed from
the engine shut-off switch, the buzzer will
sound when the Start/Stop button is
pressed.
 For twin type, when either engine has
started, the engine that has started can be
stopped by pressing the Start/Stop button
on the All Start/Stop switch panel.
EMU36510
Checks after starting engine
EMU41360
Cooling water
Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the cooling water pilot hole shows
that the water pump is pumping water
through the cooling water passages.
TIP:
When the engine is started, there may be a
slight delay before water flows from the cool-
ing water pilot hole.
NOTICE
ECM02250
If water is not flowing out of the cooling
water pilot hole at all times while the en-
gine is running, overheating and serious
damage could occur. Stop the engine and
ON
START
ZMU07169
ZMU07148
ZMU07150
6CE-9-34-1E0.book 60 ページ ２０１２年１１月２３日 金曜日 午後１時１３分